MIMAKI CG-100SRIII, Operation Manual

Page: 127 / 172

3-77
1
1
3
Useful Function
5
6
Miscellaneous Settings
Setting List
Function
name
Outline Setting values
Mark
Detect When you cut the data with registration
marks, you must set without fail.
See P.3-16.
Command
Switching
Switch the unit of moving amount
specified by a command.
AUTO
This is to automatically switch the
command according to the command
specifications of the receiving data.
MGL-IIc
This is selected when the plotter receives
the data of MGL-IIc command.
MGL-Ic1
This is selected when the plotter receives
the data of MGL-Ic1 command.
Interface Set the configuration with a computer. See P.3-52.
Cutting
Mode
This is to set the cutting quality.
Standard This is a regular cutting mode.
H i g h
speed
This is used to perform cutting in a short
time (it is not appropriate for the heavy
sheet).
H i g h
quality This is a cutting mode used to give priority
to cutting quality.
Origin
Switching
At the time of MGL-IIc command, this
function sets the position of command origin.
(At the time of MGL-Ic1 command, the
command origin is positioned in the lower right.)
Center
This is to set the command origin in the
center of effective cutting area.
L o w e r
right This is to set the command origin in the
lower right of effective cutting area.
Expands
Reduce the dead space to extend the cut-
ting (plotting) area.
See P.3-35.
Rotation Switch the cutting direction. See P.3-37.
Buzzer
With this you can control the
key-pressing sound and the
alert sound caused at the
time of error occurrence.
IP, VS, AS,
FS, ZF, ZA,
ZO
ON This is for making the buzzer sound.
OFF
This is not to make the buzzer sound
(also make no confirmation response
sound of registration mark sensor).
Division
Cut
Set the division cut.
See P.3-39.
Priority
When this plotter and the host computer
make different settings on a same item, this
function is used to set about which of the
two must be given priority to (This is only
for MGL-IIc).
Host
This is to give priority to the setting of host
computer.
Panel
This is to give priority to the setting of this
plotter.
Size
Response
Value
This is used to set the largest response
value of effective area read command
from the host computer (This is only for
MGL-Ic1).
1 to 51m
Sheet
Sensor This is to detect the sheet existence and
the sheet length.
ON This is to detect them.
OFF This is not to detect them.
Up Speed
This is to set the speed of sheet and
carriage movement when the tool is up.
Setting the speed lower makes the sheet
misalignment reduced at the time of long
sheet feeding. 5,10,20,30,
40,50,60,7
0,
*1
80,90,1
00,AUTO
(cm/s)
*1. Up to 70 for the X axis.
When setting to AUTO, the speed value
set in the TOOL conditions is used as the
up-speed.