3-54
Make the media without uncut area
By over lapping the start point and the end point arbitrarily, you can make the media without uncut area.
Specify the over cut function (valid/invalid) and the length of the over
cut. If the length of the over cut is set, when cut starts, cut will be
performed from the position to the front by the specified length and the
tool will move up going too far at the end.
Additionally, you can enable the corner cut function to perform over-
cutting of corners other than the start and end points.
1
Press the
key in the local mode.
2
Press the jog key
or
to select [SET UP] .
3
Press the
key.
4
Press the jog key
or
to select [OVER CUT].
5
Press the
key.
6
Press the jog key
or
to select OVER CUT
setting.
•
S
etting value: OFF or a value from 0.1 to 1.0mm (0.1mm unit)
7
Press the
key.
• Setting proper over cut can reduce uncut area of start and end
point of a media easy to bend. If too large value is set, the
result may have a rupture
Over cut
part
Corner cut
part
FUNCTION
ENTER/HOLD
ENTER/HOLD
0.1
~
1mm
0.1
~
1mm
ENTER/HOLD
Summary of Contents for CG-100SRIII
