ii
Setting a sheet ..................................................... 2-13
Setting a leaf sheet (cut sheet) ............................... 2-16
How to Place the Roll Sheet (CG-60SRIII) ............. 2-17
How to Place the Roll Sheet
(CG-100SRIII/CG-130SRIII) ................................... 2-19
Test cutting (plotting) ........................................... 2-22
Cutting (plotting) ................................................... 2-23
Setting the origin ..................................................... 2-23
Start cutting (plotting) ............................................. 2-24
Cut off the Sheet (Manual Cutting) ......................... 2-25
Turning the power off ........................................... 2-26
CHAPTER 3 Useful Function
Functions in the Jog Mode ..................................... 3-2
Setting the origin ....................................................... 3-2
Two-point axis alignment .......................................... 3-3
Cutting area .............................................................. 3-4
Digitization operation ................................................ 3-5
Set the distance compensation .............................. 3-6
Perform Multiple Cuttings ....................................... 3-9
Cut Out Data with Registration Mark ................... 3-11
The Flow of Cutting out the Registered Data ......... 3-11
Enter the registration mark detection mode ............ 3-11
Precautions in inputting data with registration marks . 3-12
Set for Detecting the Registration Marks ................ 3-16
Method of detecting registration marks .................. 3-21
Confirm the following when failed in cutting correctly. 3-29
Expand the cutting (plotting) area ........................ 3-35
Set the EXPANDS function to ON. ......................... 3-35
Switch the cutting (plotting) direction ................... 3-37
The Setting of ROTATION. ..................................... 3-37
Perform DIVISION cut .......................................... 3-39
Set the Y direction (width direction) DIVISION cut . 3-39
Set the X direction (feeding direction) DIVISION cut .. 3-41
Cut Data via DIVISION CUT. .................................. 3-43
Change the cutting (plotting) order ...................... 3-44
Set SORTING . ....................................................... 3-44
Sorting sequence .................................................... 3-46
Summary of Contents for CG-100SRIII
