Page 76
Telnet
CSP2008
11.6 Software Trigger
11.6.1 Activating Software Trigger
Command: SWTRIGGERENABLE 0|1
Activates the software trigger. Command works analog to the
Digital CSP2008 in-
puts
menu >
Terminal block synchronization/triggering > manual
trigger active
.
i
The input Sync/Trig must be set on trigger for running this command in the
CSP2008.
Parameter:
-
0 deactivates the software triggering
-
1 activates the software triggering
11.6.2 Initiating Software Trigger
Command: SWTRIGGER 0|1
-
Initiates a trigger pulse in case of edge triggering or
-
Initiates a trigger pulse in case of level triggering.
Command works analog to the
Digital CSP2008 inputs
menu >
Terminal
block synchronization/triggering > Activate level
.
In case of edge triggering the 1 is reset automatically; in case of level triggering the
triggering must be reset by command.
Parameter:
-
0 deactivates the software triggering
-
1 activates the software triggering
11.7 Edge Filter
Command: EDGEFILTER <Block No> <Upper threshold in mm> <Lower threshold in
mm> <Number of ignored and substitued measuring values N>
Activates the edge filter. The command works similarly to the menu
Calculation >
Block n > Edge filter.
i
First the calculation block and the data source must be configured via the web
interface for the edge filter.
11.8 Software Switching Outputs
Command: SWDIGITALOUT <Number>
<Number> specifies a decimal or a hex value of the software switching outputs set. The
individual outputs are coded in the bits:
Output 1 = bit 0, … output 10 = bit 9
Example:
Output 1 and 10 should be set.
Calculation: 1*2^0 + 1*2^9 = 513 (resp. 0x201)
Command: SWDIGITALOUT 513
Previous settings are overwritten or deleted, if the command is used a further time.
If the command is called without parameters, the current setting is returned.
Summary of Contents for CSP2008
Page 1: ...CSP2008 Instruction Manual Channel 1 in mm 14 452...
Page 79: ......
