MICRO-EPSILON CSP2008, Instruction Manual

Page: 55 / 80

Page 55
Operation
CSP2008
5.3.11.5 Digital CSP2008
Synchronous output: In this menu item, you define the pulse width of synchronization
output on the terminal block.
Statistics: In this menu item, you define, which results of calculation program
Statis-
tics
are output to the two digital terminals
Out 1
and
Out 2, see Chap. 4.3.1
.
Possible results:
- Block n - Statistics - Upper limit | Block n - Statistics - Lower limit
- Block n - Statistics - Upper warning | Block n - Statistics - Lower warning
- Block n - Statistics - IO, NIO | Block n - Statistics - Invalid meas value
Switching output active: HIGH Switching output active: LOW
Hold time Hold time
Switching output
3.3 V
0 V
Time
Switching output
3.3 V
0 V
Time
Fig. 44 Behavior of digital outputs DOUT 1 and DOUT 2
If the statistics module recognizes an invalid measurement value, no new statistic values
will be calculated.
i
If additional switching outputs are required, use EtherCAT terminals, see Chap.
5.3.11.6 .
Setup selection. Alternatively to the statistics functions the used setup file or the state of
the controller can also be confirmed via the digital outputs.
Possible results:
- Setup number bit 0 | Setup number bit 1
- Setup number bit 2 | Setup number bit 3
- Setup number bit 4 | Setup active
If the controller changes a setup file, the
Setup active
signal is disabled.
Software digital outputs. These outputs can also be confirmed via the digital outputs.
The software digital outputs are set in the
Settings > Digital CSP2008 outputs
menu or with a command, see Chap. 11.8 .
Possible results:
- SW digital out 1 | SW digital out 2
- ...
- SW digital out 9 | SW digital out 10
5.3.11.6 Digital EtherCAT
The digital EtherCAT terminals extend the choice of switching outputs.
Statistics: In this menu item you define, which results of calculation program
Statis-
tics
are output to the digital terminals. The active behavior cannot be set at the digital
EtherCAT terminals.
Possible results:
- Block n - Statistics - Upper limit | Block n - Statistics - Lower limit
- Block n - Statistics - Upper warning | Block n - Statistics - Lower warning
- Block n - Statistics - IO | Block n - Statistics - Invalid meas value
Switching output active: HIGH
Hold time
Switching output
24 V
0 V
Time
Fig. 45 Behavior of digital outputs
If the statistics module recognizes an invalid measurement value, no new statistic values
will be calculated.