M133C Electric Power/Energy Calibrator
MEATEST
47
Operation manual
10.
Energy
Submenu contains parameters that affect Energy generation.
8.1.
Energy units
Sets the unit used for energy. By selecting an item from the list Ws and Wh unit can be
selected.
8.2.
Energy - output
Contains parameters for setting the energy pulse output (BNC connector on the rear panel).
8.2.1.
Internal pull-up
This parameter allows to connect the internal pull-up resistor (150 Ω) to the Energy
pulse output.
8.2.2.
Output constant
Contains parameters for definition the constant of Energy pulse output.
8.2.2.1.
Value
This parameter sets number of pulses per selected unit (pulses generated on
Energy pulse output on the rear panel BNC).
8.2.2.2.
Unit
This parameter sets unit of Output constant value (pulses generated on
Energy pulse output on the rear panel BNC).
8.3.
Energy – input IN1
Contains parameters for setting the energy pulse input IN1.
8.3.1.
Internal pull-up
This parameter allows to connect the internal pull-up resistor (150 Ω or 1 kΩ) to the
Energy pulse input.
8.3.2.
Input filter
This parameter allows to add input filter for contact debouncing. Input
frequency with the input filter is limited to 400 Hz.
8.4.
Maintain Voltage Signal
This parameter allows to maintain the voltage signal on test completion in energy counting
modes (Packet / Counter / Timer).
11.
Dip-Swell
Submenu contains parameters that affect Dip-Swell generation.
