MEATEST
M133C Electric Power/Energy Calibrator
Operation manual
18
To get to the default screen, press „Exit“ button. All values can be set using the buttons
or the rotary knob.
Entry of the value using the rotary knob
Press the rotary knob. The display now includes cursor marks which points to the
active digit.
Turn the knob to change the active digit
Press the rotary knob to change to the mode which allows to change the value of the
active digit. ← and → symbols are displayed above the active digit. Active digit can be
changed by turning the knob.
Turn the knob to change the position of the active digit.
To get to the default screen press „Exit“ button. All values can be set using the buttons
or the rotary knob.
Note:
All parameters have limits (high and low). If the entered value is outside these limits
error message is displayed („Value too large (small)“) and new value is not accepted.
4.3
Connection / disconnection of output terminals
After switching the AC power supply on the output terminals are disconnected in all modes.
Press the “On” button to connect the output signal to the terminals. Green LED above the “On”
button is lit.
Press the “Off” button to disconnect the output terminals. Green LED goes off.
Output terminals are disconected automaticaly under following conditions:
Function mode change
Output voltage exceeds 100V. It occurs if you change the output value that is below
100V to the new value above 100V.
Calibrator is overloaded.
Changing some parameters of output signal (P Harmonic, etc.)
Changing frequency for voltage above 280V
Energy counting is finished.
Output voltage exceeds 280V while current outputs are floating. It occurs if you change
the output value that is below 280V to the new value above 280V and current outputs
