MARUTI SUZUKI Wagon R, Manual

Page: 24 / 240

0A-7 General Information:
When Using Floor Jack
WARNING
!
If the vehicle to be jacked up only at the front
or rear end, be sure to block the wheels on
ground in order to ensure safety.
After the vehicle is jacked up, be sure to
support it on stands. It is extremely
dangerous to do any work on the vehicle
raised on jack alone.
CAUTION
!
• Never apply jack against suspension parts
other than specified position or vehicle
floor, or it may get deformed.
• When jacking up the rear end, never apply
jack against fuel tank. Otherwise, it may
cause fuel leakage.
• When jacking up the front end, be sure to
use an air type floor jack with the following
specified height or a manual type floor jack
of the following size. Otherwise, the jack
may cause the bumper or vehicle body
panel damage.
Jake size
Height “h”: under 145 mm (under 5.71 in.)
Length “l”: longer 900 mm (under 35.4 in.)
In raising front or rear vehicle end off the floor by jacking,
be sure to put the jack against front suspension frame
(1) or center portion of rear axle (2).
To perform service with either front or rear vehicle end
jacked up, be sure to place safety stands (1) under body
mounting stay (2) so that vehicle body is securely
supported. And then check to ensure that body mounting
stay (2) does not slide on safety stands (1) and the
vehicle is held stable for safety’s sake.
“h”
“l”
I4RS0A010002-01
1
2
I9R90A010002-01