MARUTI SUZUKI S-Cross, Owner'S Manual

Page: 25 / 348

2-6
BEFORE DRIVING
64MS0-74E
Keyless Push Start System Remote
Controller (Type A)
The remote controller enables the follow-
ing operations:
• You can lock or unlock the doors by
operating the LOCK/UNLOCK buttons
on the remote controller. Refer to the
explanation in this section.
• You can lock or unlock the doors by
pushing the request switch. For details,
refer to the explanation in this section.
• You can start the engine without using
an ignition key. For details, refer to
“Engine Switch” in the “OPERATING
YOUR VEHICLE” section.
82PH02034
(1) LOCK button
(2) UNLOCK button
You can lock or unlock all doors (including
the tailgate) simultaneously by operating
the remote controller near the vehicle.
Central door locking system
• To lock all doors, push the LOCK button
(1) once.
• To unlock only the driver’s door, push the
UNLOCK button (2) once.
• To unlock other doors, push the
UNLOCK button (2) once again.
NOTE:
You can switch the function that unlocks all
doors from twice operations to once opera-
tion, and vice versa, via the setting mode
of the information display. For details on
how to use the information display, refer to
“Information Display” in this section.
The turn signal lights will flash once and
the siren will sound once when the doors
are locked.
When the doors are unlocked:
• The turn signal lights will flash twice and
the siren will sound twice.
• If the interior light switch is in the DOOR
position, the interior light will turn on for
about 15 seconds and then fade out. If
you press the engine switch during this
time, the light will start to fade out imme-
diately.
Be sure the doors are locked after you
operate the LOCK button (1).
If no door is opened within about 30 sec-
onds after the UNLOCK button (2) is oper-
ated, the doors will automatically lock
again.
Car locator function
This function helps in locating the vehicle.
Push both of the LOCK button (1) and
UNLOCK button (2) for more than 3 sec-
onds. The turn signal lights will blink for
about 27.5 seconds. Also, the siren will
sound for about 27.5 seconds at the same
time.
To cancel the car locator function, press
any button (LOCK OR UNLOCK). You can
also change the ignition mode to “ON” to
cancel the car locator function.
NOTE:
The car locator function will not activate
when the ignition mode is “ACC” or “ON” or
pre warning / full blast warning by shock
sensor or alarm is in activated condition.
NOTE:
• If you lock the doors using the remote
controller when the engine hood is open,
the siren will sound 3 times to remind
you.
• If the security system was triggered due
to an unauthorized entry into the vehicle
and then you unlock the doors using the
remote controller, the siren will sound 4
times to remind you. If this happens,
check whether your vehicle has been
broken into while you were away from it.
• Once you push both of the LOCK button
(1) and UNLOCK button (2), then you
push one of the buttons within 5 sec-
onds, the siren will not sound. However,
If you push one of the buttons twice
within 5 seconds, or push one of the but-
(1)
(2)
EXAMPLE