MARUTI SUZUKI S-Cross, Owner'S Manual

Page: 266 / 348

8-3
EMERGENCY SERVICE
64MS0-74E
63J101
6) Position the jack vertically as shown in
the illustration and raise the jack by
turning the jack handle clockwise until
the jack-head groove fits around the
jacking bar beneath the vehicle body.
7) Continue to raise the jack slowly and
smoothly until the tire clears the
ground. Do not raise the vehicle more
than necessary.
To Raise the Vehicle with a Garage
Jack
• Apply the garage jack to one of the points
indicated below.
• Always support the raised vehicle with
jack stands (commercially available) at
the points indicated below.
Front jacking point for garage jack (1)
64MM08001
EXAMPLE WARNING
• Use the jack only to change wheels
on level, hard ground.
• Never jack up the vehicle on an
inclined surface.
• Never raise the vehicle with the jack
in a location other than the specified
jacking point (shown in the illustra-
tion) near the wheel to be changed.
• Make sure that the jack is raised at
least 25 mm (1 inch) before it con-
tacts the flange. Use of the jack
when it is within 25 mm (1 inch) of
being fully collapsed may result in
failure of the jack.
• Never get under the vehicle when it
is supported by the jack.
• Never run the engine when the vehi-
cle is supported by the jack and
never allow passengers to remain in
the vehicle.
(1)
EXAMPLE