MARUTI SUZUKI S-Cross, Owner'S Manual

Page: 31 / 348

2-12
BEFORE DRIVING
64MS0-74E
to remind you. If this happens, check
whether your vehicle has been broken
into while you were away from it.
• Once you push both of the LOCK button
(1) and UNLOCK button (2), then you
push one of the buttons within 5 sec-
onds, the siren will not sound. However,
If you push one of the buttons twice
within 5 seconds, or push one of the but-
tons 5 seconds later, the siren will
sound.
• You can set whether the siren sounds
when locking or unlocking the door(s) via
the setting mode of the information dis-
play. For details on how to use the infor-
mation display, refer to “Information
Display”
in this section.
NOTE:
• The maximum operating distance of the
keyless entry system transmitter is about
5 m (16 ft.), but this can vary depending
on the surroundings, especially near
other transmitting devices such as radio
towers or CB (Citizen’s Band) radios.
• The door locks cannot be operated with
the transmitter, if the ignition key is
inserted in the ignition switch.
• When any door is open, the door locks
can be operated only by unlocking with
the transmitter. With this unlocking oper-
ation, the turn signal lights will flash
twice and the siren (if your vehicle is
equipped with the security system) will
sound twice.
• If you lose one of the transmitters, ask
your authorised Maruti Suzuki workshop
as soon as possible for a replacement.
Be sure to have your dealer program the
new transmitter code in your vehicle’s
memory so that the old code is erased.
Car locator function (if equipped)
This function helps in locating the vehicle.
Push both of the LOCK button (1) and
UNLOCK button (2) for more than 3 sec-
onds. The turn signal lights will blink for
about 27.5 seconds. Also, the siren will
sound for about 27.5 seconds at the same
time.
To cancel the car locator function, press
any button (LOCK or UNLOCK). You can
also turn the ignition switch to the “ON”
position to cancel the car locator function.
NOTE:
The car locator function will not activate
when the key is in the ignition switch or pre
warning / full blast warning by shock sen-
sor or alarm is in activated condition.
Replacement of the battery
If the transmitter becomes unreliable,
replace the battery.
To replace the battery of the transmitter:
68LM248
1) Remove the screw (1), and open the
transmitter cover.
2) Remove the transmitter (2).
NOTICE
The transmitter is a sensitive elec-
tronic instrument. To avoid damaging
the transmitter:
• Do not expose it to impacts, mois-
ture or high temperature such as
by leaving it on the dashboard
under direct sunlight.
• Keep the transmitter away from
magnetic objects such as a televi-
sion.
NOTICE
When replacing the battery, do not
touch the electronic component in
the transmitter with wet or oil-stained
hands. Otherwise, the transmitter
may be damaged.
(1)
(2)
EXAMPLE