MagneMotion MagneMover LITE, User Manual, Page: 224 / 382

Installation
Transport System Installation
38 MagneMotion
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
Installing Motor Power Cables
Refer to Figure 4-1 on page 4-3 through Figure 4-8 for the power connection locations on the
motors and switches in the MagneMover LITE transport system and Figure 4-39 for the
power connection locations on the power supply. Refer to Figure 5-18 and Figure 5-19 for
simplified diagrams of the wiring. Figure 5-22 shows the power connections being made to
the bottom of the motor.
Figure 5-22: Power Connections
NOTE: The AC power connections will be made at a later time (refer to Facilities Connec-
tions on page 5-60 ).
Refer to Electrical Wiring on page 3-12 to ensure all power wiring is properly sized.
Refer to Table 4-1 on page 4-38 when connecting the power cables to the motors to
ensure each chain of motors does not exceed the rated output of the power supply
(600 W). MagneMotion recommends a maximum of 10 motors be connected to J1 or
J2 on the power supply at one time (20 motors per power supply).
NOTICE
If a user-supplied power supply is used it must be NRTL/ATL approved.
J1
J2
GN
D
J4 D
C EN
ABL
E
(SE
E MA
NUA
L FO
R PI
NOU
T)
36 V
DC
300
W
36 V
DC
300
W
GN
D
V+
PRO
PUL
SION
V+
LOG
IC
V-
RET
URN
V+
LOG
IC
V-
RET
URN
V+
PRO
PUL
SION
J3
Motor Power Connector
Power
Power Bus Cable
T-Splitter Power Cable
Power Bus End Cap
Power Cable
Supply
Ground