Installation
Transport System Installation
12
MagneMotion
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
Installing System Legs
Once the beam sections are assembled the legs must be attached.
1.
Invert the beam and place on a clean work surface.
NOTE:
Ensure the beam is inverted as some sections have an orientation and must be
installed correctly to enable mounting of the motors.
2.
Attach the Single Path Legs at the appropriate locations (if not already installed) as
shown in
NOTE:
Orient the feet as required to allow proper final installation of the beam.
Figure 5-2: Leg on a Single Path Beam Assembly
A.
Insert two M8 T-nuts and rotate into position in the channel on the bottom of
the beam where the leg will be attached (T-nuts must be inserted so that the
spring steel tabs are facing toward the beam then rotated clockwise into place).
B.
Position the leg over the T-nuts, apply Loctite 243 to two M8 x 25 mm screws
and install and tighten the screws to 26 N-m [230 in-lb] using a 6 mm Hex bit.
NOTE:
The Loctite must cure for 2 hours at 22° C [72° F] before using the
transport system.
Leg Stand Assembly
Beam
M8 T-Nut
(2X)
M8 x 25 mm Screw
(2X)