Introduction
Getting Started with the MagneMover LITE Transport System
MagneMover LITE User Manual
11
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
Node Controller Software Installation
Node Controller Web Interface User’s Manual
).
6.
Program the motors using the Motor Image Files (refer to
Node Controller Web Interface User’s Manual
and
NCHost TCP Interface Utility User’s Manual
).
7.
Test and debug the transport system by using the NCHost TCP Interface Utility and
Demo Scripts (refer to
and the
NCHost TCP
Interface Utility User’s Manual
). This provides an easy method to verify proper opera-
tion and make adjustments such as refining the control loop tuning.
NOTE:
The NCHost TCP Interface Utility is for test and verification trials only. The
user’s Host Controller must be used to control the MagneMover LITE trans-
port system after verification of functionality.
8.
Configure the Host Controller (either PC or PLC based) to control the MM LITE
transport system as required to meet the material movement needs of the facility where
the system is installed (refer to either the
Host Controller TCP/IP Communication
Protocol User’s Manual
, the
Host Controller EtherNet/IP Communication Protocol
User’s Manual
, or the
Mitsubishi PLC TCP/IP Library User’s Manual
). Refer to:
•
•
.