MagneMotion MagneMover LITE, User Manual, Page: 350 / 382

Maintenance
Repair
66 MagneMotion
Rockwell Automation Publication MMI-UM002E-EN-P - March 2016
B. Clean the magnet assembly using isopropyl alcohol to remove any residue.
C. Remove the backing from the new protective strip and place it on the magnet
assembly by centering the round hole at the end of the strip over one of the
threaded standoffs and folding the strip around the bottom of the magnet
assembly and over the other standoff as shown in
Figure 7-28 . Press the strip
into place using a burnisher, ensuring there are no bubbles.
3. If a new center plate is being installed, remove the backing and apply the glue dot to
the depression in the middle of the septum on the center plate as shown in
Figure 7-28 .
4. If necessary, replace the spacers in the center plate as shown in Figure 7-28 .
5. If necessary, replace the skis on the pallet as shown in Figure 7-28 .
A. Remove the M4 screw securing each ski using a 2.5 mm Hex wrench.
B. Clean the bottom surface of the pallet using isopropyl alcohol to remove any
debris.
C. Install the new skis by locating them into the features on the bottom of the pal-
let.
D. Place two to three drops of Loctite 243 on the threads of each M4 x 8 mm flat
head screw. Secure the skis to the pallet using the two M4 x 8 mm flat head
screws, and tighten to 1.5 N-m [13 in-lb].
6. Align the pallet with the spacers on the center plate and seat it into place.
7. Place two to three drops of Loctite 243 on the threads of each M4 x 20 mm flat head
screw. Secure the pallet to the magnet array using the two M4 x 20 mm flat head
screws, and tighten to 1.5 N-m [13 in-lb].
NOTE: The Loctite must cure for 2 hours at 22° C [72° F] before using the puck.
8. Replace the puck on the MM LITE transport system (refer to Replace Pucks on
page 7-35 ).