215922
354
Revision A
1034235
A
Figure 5.197: Signal Repeater
7.
To install turn/hazard repeater lamp (D) shown in Figure
, align lamp tab (A) with the slot in the
placard, gently push the lamp into the placard, and rotate it
to secure it.
8.
Connect the electrical harness to the receptacle on the rear
of the lamp.
Replacing Beacon Lights
1019726
A
B
C
D
E
F
G
Figure 5.198: Beacon Light Assembly
1.
Disconnect wiring (A) from the harness.
2.
Remove nuts (B) and remove beacon (C). Discard the
defective beacon and hardware.
3.
Clean any residue from support (D) mounting surface.
4.
Install new beacon (C) with gasket (E) onto the support.
Secure it with bolts (F), washers (G), and nuts (B).
5.
Torque the nuts to 0.65 Nm (0.48 lbf·ft).
Replacing Cabin Dome Bulb
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the ignition.
