215922
296
Revision A
1007544
A
B
C
Figure 5.96: Drive Wheel
1.
Park the windrower on level ground.
2.
Position windrower so that plugs (A) and (B) are
horizontally aligned with center (C) of the hub.
WARNING
Use caution when removing plug as there may be pressure in
the drive.
3.
Remove plug (A) or (B). The lubricant should be visible
through the port or running out slightly. If lubricant needs
to be added, refer to
5.10.4 Adding Wheel Drive Lubricant
.
NOTE:
The type of lubricant used after the first lubricant change is
different from the factory supplied lubricant.
4.
Reinstall the plugs and torque to 24 Nm (18 lbf·ft).
5.10.4
Adding Wheel Drive Lubricant
–
10 Bolt
NOTE:
Do
NOT
mix lubricants of different brands or characteristics.
NOTE:
For lubricant specifications, refer to
5.1.4 Lubricants, Fluids, and System Capacities, page 232
.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator
’
s seat for any reason.
1007544
A
B
C
Figure 5.97: Wheel Drive
1.
Rotate the wheel drive so plugs (A) and (B) are horizontally
aligned with center (C) of the hub.
2.
Shut down the engine, and remove the key from
the ignition.
3.
Remove either plug (A) or (B).
NOTE:
PRIOR TO FIRST CHANGE:
Use SAE 85W-140, API service,
class GL-5, extreme pressure gear lubricant (non-synthetic).
NOTE:
AFTER FIRST CHANGE:
Use SAE 75W-140 or 80W-140, API
service, class GL-5, fully synthetic transmission lubricant
(SAE J2360 preferred).
4.
Add lubricant through one of the ports until the lubricant
reaches the bottom of the ports and begins to run out.
5.
Reinstall and tighten plug (A) or (B). Torque plug to 24 Nm
(18 lbf·ft).
6.
Start up and operate the windrower for a few minutes, then stop and check the oil level. For specifications, refer to
5.1.4 Lubricants, Fluids, and System Capacities, page 232
. If necessary, add more oil.