215922
166
Revision A
4.5
Attaching and Detaching a Header to the Windrower
This chapter specifies which headers are compatible with the windrower and provides instructions for attaching and
detaching the header.
4.5.1
D1X or D1XL Series Draper Header
This section details the procedures necessary to physically attach a D1X or D1XL header to a windrower and to attach its
hydraulic and electrical connections. The procedures may vary slightly depending on the configuration of the windrower.
Attaching Draper Header Supports
Draper header supports are required to attach the header to the windrower.Draper header supports are required to attach
the header to the windrower.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator
’
s seat for any reason.
If not installed, attach the draper header support (supplied with the header) to the windrower lift linkage as follows:
1.
Shut down the engine, and remove the key from the ignition.
1015587
A
B
Figure 4.98: Draper Header Support
2.
Remove the hairpin from clevis pin (B) on draper header
support (A). Remove clevis pin (B).
1015593
A
B
C
D
Figure 4.99: Draper Header Support
3.
Position draper header support (B) on windrower lift
linkage (A). Reinstall clevis pin (C).
NOTE:
To ensure that the pin doesn
’
t snag the windrow, install the
clevis pin on the outboard side of the draper header
support.
4.
Secure clevis pin (C) with hairpin (D).
5.
Repeat Step
to Step
to install the
remaining draper header support.
