215922
207
Revision A
1015881
A
B
Figure 4.193: Lift Linkage
DANGER
Ensure that all bystanders have cleared the area.
11. If adjustment is necessary, start the engine and resume the
float. Lower the header onto the ground until member (A)
lifts away from link (B) on both sides.
12. Shut down the engine, and remove the key from
the ignition.
1015880
A
B
Figure 4.194: Lift Linkage Shims
13. On the side that is higher, remove nut, washer, and bolt (A)
that attaches shims (B) to the linkage.
14. Remove one or both of shims (B) and reinstall
hardware (A).
DANGER
Ensure that all bystanders have cleared the area.
15. Repeat Step
to Step
to rephase
the cylinders and check the header level.
16. If additional adjustment is required, repeat Step
to Step
, and install one of the removed
shims on the opposite linkage.
17. Reset the header float. Refer to
NOTE:
Additional shims are available from your Dealer.
4.7.5
Adjusting Reel Speed
Reel speed is displayed in either rpm, mph, or km/h (depending on the global units selection). The default reel speed is
60 rpm and can be set to auto or manual mode.
•
AUTO mode: Minimum reel speed and operating reel speed differential relative to ground speed are set, and reel speed
is maintained relative to ground speed. For instructions, refer to
Setting Reel Speed in Auto Mode, page 208
.
•
MANUAL mode: Reel speed is set and is maintained regardless of ground speed. For instructions, refer to
Speed in Manual Mode, page 209
.
NOTE:
Both speed modes work with the One-Touch-Return feature. For example, button A on the GSL can be set for MANUAL
mode and button B can be set for AUTO mode. For instructions, refer to
One-Touch-Return Buttons, page 77
.