215922
353
Revision A
1034230
A
B
C
D
Figure 5.194: Amber and Marker Lights
–
Front View
3.
To remove amber turn/hazard lamp (A) or red marker
lamp (B), disconnect the electrical harness connector from
the rear of lamp, remove screws (C) with washer and bolts,
and press the lamp away from the placard.
4.
To remove signal repeater (D), disconnect the electrical
harness from the lamp.
1034235
A
Figure 5.195: Signal Repeater
5.
Rotate the lamp connector to align tab (A) with the slot in
the placard. Press tab (A) and push the lamp out from the
placard.
1034231
A
B
C
D
Figure 5.196: Amber and Marker Lights
–
Front View
6.
To install amber turn/hazard lamp (A) or marker lamp (B),
secure the lamp with two screws, washers, and bolts (C),
and connect the electrical harness to the receptacle on
lamp. For plug locations, refer to Table