Lightwave Research Status Cue, User Manual, Page: 54 / 348

1-14 Status Cue User’s Manual
Status Cue Cabling
The following subsections show how to properly connect all cables for
operation of the Status Cue Console and attached devices.
Connect Console Cable
The Console to LinkCard cable is a 10 foot shielded cable with a “locking” right
angle DB-25 connector on the Console end and a straight DB-25 connector on the
LinkCard end. Pins 3 and 25 are not used in the cable. See Figure 1.12
.
Figure 1.12. Console Cable to LinkCard
To install the Console cable from Console to LinkCard:
1. Connect the right angle connector to the “Console LINK” connector located at
the rear of the Console (Figure 1.13) with the cable dressed towards the right
side of the Console (looking from rear). This allows cable clearance when you
open the Console. Then, slide the connector locking mechanism to the left to
secure the connector to the Console. Refer to Figure 1.14.
.
Figure 1.13. Console Rear Panel
10 feet
connect to
Master LinkCard
connect to
Console
right angle
straight DB-25
(male)
DB-25
(female)
CONSOLE
LINK
EXTERNAL
CONTROL
EXT IN 1
EXT IN 2