Lenovo ThinkServer TS430, Hardware Maintenance Manual

Page: 44 / 264

• Each of the hard-disk-drive bay ( 5 to 8 ) is used for installing a 3.5-inch non-hot-swap hard disk drives.
Note: The number of the installed hard disk drives varies by model.
• For information about the supported expansion card, see “System board components” on page 45.
• Depending on the model, your server might come with a screw-secured, non-hot-swap power supply
assembly or one or two hot-swap redundant power supplies.
• For more information about the memory modules, see “Memory module installation rules” on page 94.
Hot-swap hard-disk-drive status LEDs
This topic applies only to server models with hot-swap hard disk drives.
Note: Depending on the model, your server might look slightly different from the illustrations in this topic.
Each hot-swap hard disk drive has two status LEDs on the front. Unlock and open the front door to gain
access to the hard disk drives and view the status LEDs.
Figure 15. 3.5-inch hot-swap hard-disk-drive status LEDs
32
ThinkServer TS430 Hardware Maintenance Manual