Lanier Copier System Edition, Operating Instructions Manual

Page: 819 / 1270

Operating Instructions Scanner Reference
103
When the Error Message Is Displayed on the Control Panel
Note
❒
If an error message that is not contained in this section appears, turn off the main power switch of
the machine, and then turn it on again. If the message is still shown, note the content of the message
and the error number (if listed in the table), and contact your service representative. For information
about how to turn off the main power switch, see
p.111 “Powering Off the Machine” .
Message Causes and Solutions
Cannot communicate with server.
Check the server status. The scanned data will be stand
by.
No response from the delivery server. Possible causes are
as follows:
• The delivery server is not running or has not started
delivery service.
• "Delivery Server IP Address" is not set correctly in
System Settings.
• The delivery server does not recognize the connected
device. Program a connected device in "Set I/O De-
vice" of ScanRouter V2 Administration Utility.
⇒
ScanRouter V2 Administration Utility Help
• The machine may not be correctly connected to the
network. Check the LED indicators of the Ethernet
board.
⇒
Administrator Reference 1
Cannot detect original size.
Select scan size and reset originals.
• Place the original correctly.
• Specify the scan size.
• When placing an original directly on the exposure
glass, the opening/closing action of the ADF triggers
the automatic original size detection process. Raise
the ADF by more than 30 degrees.