Lanier Copier System Edition, Operating Instructions Manual

Page: 33 / 1270

Replacing Consumables and Maintenance Kit
22
1
Note
❒
If the toner has almost run out
or Auto Adjustment has not fin-
ished, the Fuser Adjustment
procedure cannot be carried
out. Carry out the Fuser Adjust-
ment procedure after replenish-
ing the toner or after Auto
Adjustment has finished.
TTTT
Load the A3 paper that comes
with the new Fusing Unit in the
Bypass Tray, and then press
[ Start
Printing ] .
The printer prints 8 Test Sheets (A-
H).
UUUU
After printing the Fuser Adjust-
ment Sheet, the Fuser Adjustment
display appears. Adjust the print
settings for boxes A - H on the
Fuser Adjustment Sheet.
Note
❒
Check the printed Fuser Adjust-
ment Sheet to adjust the print
settings.
A
Compare box A of the pattern
with the white square in the
printed Fuse r Adjustment
Sheet. If the pattern is the same
as the printed Fuser Adjust-
ment Sheet, press
[ Clear ] . If it is
not, do not press [ Clear ] .
Note
❒
If you press [ Clear ] again, set-
ting will be cancelled.
B
Repeat step
A A A A
to make the set-
tings for boxes B to H.
C
After making all the settings,
press
[ OK ] .
Note
❒
If [ Clear ] is not pressed for
one of the boxes, the follow-
ing display appears. Press
[ Exit ] and repeat the proce-
dure from step
A
.
VVVV
After making all the settings,
press the
{{{{
User Tools/Counter
}}}}
key.
The initial display is shown.