Lanier Copier System Edition, Operating Instructions Manual

Page: 48 / 1270

Adjusting the Color Registration
37
2
Fuser Adjustment
When replacing the fusing unit
Note
❒
If the toner has almost run out or
Auto Adjustment has not finished,
the Fuser Adjustment procedure
cannot be carried out. Carry out
the Fuser Adjustment procedure
after replenishing the toner or after
Auto Adjustment has finished.
AAAA
Load the A3 paper that comes
with the new Fusing Unit in the
Bypass Tray.
BBBB
Press the
{{{{
User Tools/Counter
}}}}
key.
"User Tools/Counter" appears on
the panel display.
CCCC
Press [ Maintenance ] .
DDDD
Press [ Color Registration ] .
EEEE
Press [ At Unit Replacement ] .
Important
❒
When the toner cartridge is al-
most empty or "Auto Adjust-
m e n t " i s n o t f i n i s h e d , t h e
following message appears on
the panel display and Fuser Ad-
justment is not available.
Confirm that the toner is not emp-
ty. If the toner is empty, replace the
toner cartridge.
If the toner cartridge is not empty,
perform "Auto Adjustment". See
p.36 “Auto Adjustment”.
FFFF
Press [ Print Fuser Adjust. Sheet ] .
GGGG
Confirm that the A3 paper that
comes with the Fusing Unit is in
the Bypass Tray, and then press
[ Start Printing ] .
The printer prints 8 Test Sheets (A-
H). For more information about
Test Sheets, See p.42 “Test Sheet
Samples”.