L-3 Communications Office STE, User Manual

Page: 229 / 312

STE User’s Manual Remote Control Operations
Rel. 2.6 8-19
Table 8-6. S-Register Summary
Register Description
S14 a. S14 is bit mapped to store the options listed below:
Bit Option Values
0 Reserved 0
1 Command Echo (E) 0 = Disabled
1 = Enabled *
2 Result Codes (Q) 0 = Enabled *
1 = Disabled
3 Verbose Mode (V) 0 = Numeric result codes
1 = Verbose result codes *
4 Display Messages (+Q) 0 = Enabled *
1
= Disabled
5 Dial Method on PSTN 0 = Tone *
1
= Pulse
6 Reserved 0
7 Answer/Originate 0 = Answer *
1 = Originate
* = Factory Default
b. The default value for S14 is 10.
c. If an attempt is made to set bit 0 or bit 6 (reserved bits) to 1, send the error result code to
the DTE and leave the register unchanged.
S21 a. S21 is bit mapped to store the options listed below:
Bit Option Values
0 Reserved 0
1 DSN 0 = Disabled *
1 = Enables AUTOVON Pre-
emption signal detection when
implemented for the network
in use.
NOTE
DSN in not currently implemented
in Remote Control.
2 Reserved 0
3 Reserved 0
4 Reserved 0
5 DCD (&C0, 1) 0 - see &C0 *
1 - see &C1
6 Reserved 0
7 Reserved 0
* = Factory Default
b. The default value for S21 is 0.
c. If an attempt is made to set bits 0, 2, 3, 4, 6, or 7 (reserved bits) to 1, send the error
result code to the DTE and leave the register unchanged.
d. If an attempt is made to set bit 1 (DSN) to 1 when the terminal does not support
AUTOVON Pre-Emption on the selected network, send the error result code to the DTE
and leave the register unchanged.
NOTE
Although DSN is not currently implemented in Remote Control, an attempt to set bit 1 will be
ignored, and will not return an error result code.