Kyocera Copystar CS 3011i, Service Manual

Page: 186 / 772

2RG/2RH
1-3-103
*: Reduce the specified value if the punch position is shorter than specified.
Increase the specified value if the punch position is longer than specified.
3.Press the [Start] key to set the setting value.
Setting: Width Front HP / Width Tail HP
1.Select [Width Front HP] or [Width HP].
2.By using the [+] [-] keys or the numeric keys, change the setting value.
3.Press the [Start] key to set the setting value.
4.Press the [Stop] key to return to the screen to select the maintenance item No.
5.Enter U240 and select [Motor] and then [Width Test(A4R)].
*: The middle tray side registration guides move to A4R size position.
6.Insert paper into the side registration guides to check the consistence.
7.Repeat the above adjustment until the consistency is appropriate.
Setting: [Shift Front HP/Shift Tail HP]
1.Select [Shift Front HP] or [Shift Tail HP].
2.Change the setting value using the +/- keys or numeric keys.
3.Press the start key. The value is set.
4.Press the stop key. The screen for selecting a maintenance item No. is displayed.
5.Enter maintenance mode U240 and select [Motor], then [Sort Test].
6.Repeat the above adjustment until eject paper is properly in position.
Content to adjust Setting
range
Initial setting Data varia-
tion
Front width adjuster home position adjust-
ment -30 to 30 0 0.97mm
Rear width adjuster home position adjustment -30 to 30 0 0.97mm
Content to adjust Setting
range
Initial setting Data varia-
tion
Adjustment of front shift home position -30 to 30 0 0.97mm
Adjustment of rear shift home position -30 to 30 0 0.97mm
Center line
(within ± 0.5 mm)
Sample 1 Sample 2