Ch.2 Unpacking and Installation
< 33 >
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
1
Take out the six screws holding the exposure
unit cover in place and remove the cover.
2
Remove the two screws (at both ends) of the
tree securing the protective parts for fixing the
rear side of the exposure unit, and pull out these
protective parts.
•
Next, remove the protective parts from the front
panel of the exposure unit.
2.4.3
Removing protective parts from the Front Panel of the exposure unit
How to remove the protective parts from the front of the exposure unit following the removal from the
rear panel of the exposure unit is set out below.
1
Take out the eight screws holding the protector
at the front of the exposure unit in place and
remove the protector.
•
Next, remove the protective film from the exposure
unit conveyor roller.
The exposure unit cover
is fastened to the main
body by a hook on its
underside. To remove,
take out all the securing
screws and lift slightly.
All removed protective
parts should be
returned to their
respective return
packing bags and taken
back for re-use.
Hook
Underside of
exposure unit
When handling the
interior of the exposure
unit, be careful not to
cut fingers on the steel
belt.
When removing the
protective parts for
fixing the exposure unit
at its back, be careful
not to damage the
internal parts of the
DRYPRO 771.
Summary of Contents for DRYPRO 771
