Konica Minolta DRYPRO 771, Installaton Manual

Page: 66 / 100

Ch.3 Settings
< 64 >
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
S20 PRINT COND. /.
CH 1 CS-1
1
Start up the service maintenance mode.
2
Select "U80 SERVICE MODE" and press the
[enter] key.
• The message "S00 DICOM SCP" will be displayed.
U80 SERVICE MODE /.
S00 DICOM SCP /.
3
Press the lower [menu/select] key twice.
• The message "S20 PRINT COND." will be
displayed in the message display window.
4
Use the [menu/select] key to choose the
diagnostic device for which settings are to be
made.
• The channel will be switched.
5
Press the [enter] key.
• The setting item input screen will be displayed.
6
Input the necessary characters or digits in each
of the setting windows.
• Items for setting may be selected using the
[menu/select] key.
• The example at left shows the stamp (date) input
screen ("S21 STAMP SELECT TIME/DATE").
7
Press the [enter] key after completing all input
and settings.
• After registering the settings, the screen returns to
the maintenance menu screen.
.
.
.
.
S21 STAMP SELECT .
TIME/DATE ON
S10 DICOM SCU /.
CH 1 CS-1
The cursor will flash
below the position for
input. The cursor may
be shifted by using the
[select] key.
p.38 Starting up the
Service
Maintenance
Mode
Pressing the [mode]
key will switch the input
mode between
alphabetical characters
and numerical digits.
When [exit] key is pressed in the "PRINT CONDITION Setting" of the service
maintenance mode, a confirmation screen will be displayed. Select "YES" or "NO" for
the register of the changed data using [select] key [
[ ][ \ ].
When "YES" selected : Changes to the setting (data) are registered, and the
display returns to the maintenance menu screen.
When "NO" selected : Display returns to the maintenance menu without
registering the changes to the setting (data).
Data was changed
Save the data? YES