Konica Minolta DRYPRO 771, Installaton Manual

Page: 72 / 100

Ch.3 Settings
< 70 >
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
(4) Selecting the standard LUT which will be used by each channel.
Set the standard LUT that will be used when the LUT is not specified by the external device or
when "S31DEFAULT LUT" is set "P-CON".
At the same time, "U30 PRINT COND." of the user maintenance mode is set.
Set the print condition for each diagnostic device to handle the case where there is no print
condition specified by the diagnostic device.
Print conditions to be set are listed below.
Message Item Name Default Description
U30 PRINT COND.
Select Diagnostic Dev. -
U31 LUT NO.
User LUT USER1
U32 DENSITY
Density 0
U33 CONTRAST
Contrast 0
U34 SMOOTHING
Smoothing Type 2
U35 MAX DENSITY
Max. Density 300
U36 MIN DENSITY
Min. Density 20
U37 ORIENTATION
Film Orientation PORTRAIT
U38 IMAGE POLARITY
Image Polarity POSI
U39 TRIM ON/OFF
Trim ON/OFF CH1 : OFF
CH2 : ON
U3A BORDER
Border Color BLACK
U3B ILLUMINATION
Light Table 2000
Illuminance
U3C AMBIENT LIGHT
Ambient Light 10
Selection of the diagnostic device for which print
parameters will be set.
Selection of User LUT with which the print condition is
set.Select 4 User Luts from 7 User Luts. Select from
"USER1", "USER2", "USER3", "USER4".
Image density setting. Settings may be made within a
range of -7 to +7. Incrementing the value produces lighter
density, decrementing the value produces darker density.
Image contrast setting. Settings may be made within a
range of -7 to +7. Incrementing the value produces higher
contrast, decrementing the value produces lower contrast.
Image smoothing type setting. Settings may be made
within a range of 0 to 7. In the range of "0" through "6", the
higher the value, the smoother the image. However, the
image becomes blurred when the set value is too large.
Setting at "7" gives the same smoothness as "0" while
prints the image at 100% without magnification.
Recommended setting is "2" or "3".
Setting of the maximum density for printing.
The higher the value, the higher the maximum density, the
lower the value, the lower the maximum density.
Setting of the minimum density for printing.
The higher the value, the higher the minimum density, the
lower the value, the lower the minimum density.
Selection may made between "PORTRAIT" and
"LANDSCAPE".
Selection may be made between "POSI"(positive) and
"NEGA"(negative).
Selection may be made between the image printed with
trim or not..
Selection of border colour. Select from black (BLACK)
or white (CLEAR).
Light table brilliance setting. Normally it is sent from the
modality. Setting should be made in the range of "0"
through "38000".
Ambient light setting.
Normally sent from the modality.