Konica Minolta DRYPRO 771, Installaton Manual

Page: 41 / 100

Ch.2 Unpacking and Installation
< 39 >
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
1
Remove the five screws "a"(truss screws,
M4x12) securing the rear cover.
Rear Cover
a
a
a
a
a
b
b
2
Loosen the two screws "b" (truss screw, M4x12)
on the bottom of the rear cover.
3
Slightly lift the rear cover, and remove it.
4
Loosen the two screws (TP screw, M3x6), and
move the cleaning retraction motor unit till it is
disengaged from the gear.
5
Hold the rewind shaft of the cleaner unwoven
cloth roll, and turn the gear counterclockwise till the
waviness is visually judged to be removed.
• After the waviness is removed, proceed to the
following "Installing the Parts".
2.4.8 Adjusting the Cleaner Unwoven Cloth
If it is found that the cleaner unwoven cloth is wavy when removing the protective sheet for the heat
processing drum, manually rewind the unwoven cloth to remove the waviness by moving the
cleaning retraction motor. How to remove the waviness is described below.