Konica Minolta DRYPRO 771, Installaton Manual

Page: 33 / 100

Ch.2 Unpacking and Installation
< 31 >
DRYPRO MODEL 771 INSTALLATION MANUAL Ver.1.00 2003.10
2.4 Removing protective parts (Red)
To prevent damage to the internal components of the DRYPRO 771 during shipment due to shock or
vibration, the interior of the unit is protected by protective parts.
This material should be removed following the procedure detailed below.
protective parts should be removed after the unit has been conveyed to the place of installation.
These materials are necessary when moving the unit and should be stored for use at such times.
2.4.1 List of protective parts (Red)
The following protective parts (red) are used to with the DRYPRO 771.
Protector for the rear of the optics unit (x2)
Protector for the front of the optics unit
Protective film for the exposure unit conveyor roller
(2 sheets)
Supply unit protector
Heat roller protective sheet
Provides support at the rear of the exposure unit.
Provides support at the front of the exposure unit.
Conveyor rollers in the optics unit are protected
by two sheets of film.
Protects the supply unit.
Protects the heat roller.
Protective Material
(red component) Type page
32
33
34
35
37
Protector for the rear of the exposure unit (X2)
Protector for the front of the exposure unit
All removed protective
parts should be
returned to their
respective return
packing bags and taken
back for re-use.
Starting up the
DRYPRO 771 with
protective parts still in
place may result in
damage.
Supply Unit Protector