![background image](http://html2.mh-extra.com/html/keithley/6514/6514_instruction-manual_4064199144.webp)
Limit Tests
10-13
A) FEED <name>
Name parameters:
•
CALCulate1 — Limit tests will be performed on the result of a math calculation (mX+b
or percent).
•
SENSe — Limit tests will be performed on the input signal. Note however, that Rel can
be used on the result of a math calculation as well as the input signal. Limit tests will be
performed on the result of the Rel operation (see CALCulate2:NULL). Details on rela-
tive, mX+b and percent are provided in Section 7.
B) <NDN> and <NRf> parameters
<NDN> = #Bxxxx
Binary format (each x = 1 or 0)
= #Hx
Hexadecimal format (x = 0 to F)
= #Qxx
Octal format (x = 0 to 17)
<NRf> = 0 to 15
Decimal format
An output pattern is set by sending a parameter value that corresponds to the 4-bit BCD pat-
tern of the output. The parameter value can be sent in the binary, decimal, hexadecimal, or octal
format. For example, if you wish to set lines 4, 2, and 1 HI, the binary parameter value would
Command
Description
Default Ref
:SOURce2
SOURce2 Subsystem:
:TTL <NDN> or <NRf>
Specify 4-bit digital output clear pattern.
15
B
:CLEar
Clear I/O port (return output to TTL pattern):
[:IMMediate]
Clear I/O port immediately.
:AUTO <b>
Enable or disable auto-clear.
OFF
:DELay <n>
Specify delay (pulse-width) for pass/fail
pattern; 0 to 60 (sec).
0.0001
:TTL4
Line 4 Mode configuration:
:MODE <name>
Select output line 4 mode; EOTest or BUSY.
EOT
:BSTate <ttl>
Select active TTL level for busy; 1 (HI) or 0 (LO).
0
Trigger Subystem:
Sec 9
ARM
Arm Layer:
:SOURce <name>
Select control source; NSTest, PSTest or IMMediate.
IMM
E
INITiate
Initiation one trigger cycle.
D
FORMat
FORMat subsystem:
:SOURce2 <name>
Select data format for reading output patterns:
<name> = ASCii
Decimal format
HEXadecimal
Hexadecimal format
OCTal
Octal format
BINary
Binary format
ASC
Table 10-2 (cont.)
SCPI commands — limit tests
Summary of Contents for 6514
