3-12
Return to
Section Topics
2308-900-01 Rev. A / July 2008
Section 3: Pulse Current Measurements
Model 2308 Portable Device Battery/Charger Simulator User’s Manual
See
To change the trigger level setting for a current range
for information on setting the trigger
level setting for a current range. For the charger channel (#2), the trigger level setting is only
available on the 5 A range.
SCPI programming - pulse current measurements
The commands for pulse current measurements are summarized in
Table 3-3
(a listing following
the table contains specific command notes).
Programming examples
demonstrate how to use
these commands.
NOTE
Setting the trigger level and/or the current range may cause the PULSE CURR
TRIG NOT DETECTED message to appear.
Table 3-3
SCPI commands - pulse current measurements
Command
Description
Default
SENSe[1]
SENSe subsystem for battery channel (#1):
:FUNCtion “PCURrent”
Select pulse current measurement function.
VOLT
:PCURrent
Pulse current configuration:
:AVERage <NRf>
Specify average count:
1–100 (pulse current measurements) or
1–5000 (pulse current digitization).
1
:MODE <name>
Select measurement mode; HIGH, LOW or AVERage.
HIGH
:TIME
Set integration times:
:AUTO
Integration times set automatically.
:HIGH <NRf>
Specify integration time (in sec) for high pulse
measurements; 33.33e-6 to 0.8333.
3.333e-5
:LOW <NRf>
Specify integration time (in sec) for low pulse
measurements; 33.33e-6 to 0.8333.
3.333e-5
:AVERage <NRf>
Specify integration time (in sec) for average pulse
measurements; 33.33e-6 to 0.8333.
3.333e-5
:DIGitize <NRf>
Specify integration time (in sec) for digitizing or burst
measurements; 33.33e-6 to 0.8333.
3.333e-5
:SYNChronize
Pulse detection triggering:
[:STATe]
Send ON to select pulse current measurements or
OFF to select pulse current digitization.
ON
:TLEVel
Trigger level:
[:AMP] <NRf>
Set the trigger level in amps for use when on the 5 A
current range: 0.0 A-5.0 A in 5 mA steps.
0.0
:HUNDred <NRf>
Set the trigger level in amps for use when on the
500mA current range: 0.0 mA-500 mA in 0.5 mA or 500
μ
A
steps.
0.0
:FIFTy <NRf>
Set the trigger level in amps for use when on the
50 mA current range: 0.0 mA-50 mA in 0.05 mA or 50
μ
A
steps.
0.0
:FIVE <NRf>
Set the trigger level in amps for use when on the 5 mA
current range: 0.0-5 mA in 0.005 mA or 5
μ
A steps.
0.0
Summary of Contents for 2308
