![background image](http://html2.mh-extra.com/html/keithley/2308/2308_user-manual_3948247025.webp)
2308-900-01 Rev. A / July 2008
Return to
Section Topics
1-9
Model 2308 Portable Device Battery/Charger Simulator User’s Manual
Section 1: Getting Started
readings. The # symbol indicates the active channel (see
Section 2
for details). For both
channels, the output state is indicated by:
• 0 (zero) if the output is OFF for that channel.
• l (lowercase L) if the output is ON for that channel..
•
PULSE CURRENT
- This mode is used to display high, low, or average pulse-current
measurements (see
Section 3
for details)
•
LONG INTEGRATION
- This mode is used to display average current measurements of a
pulse or pulses measuring periods between 850 msec to 60 sec (60 Hz line frequency) and
840 msec to 60 sec (50 Hz line frequency) (see
Section 4
for details).
•
DVM INPUT
(charger channel only)
- This mode is used to display the DC voltage applied to
the DVM input of the power supply (see
Section 2
for details).
Use the SAVE SETUP item of the MENU to save the selected display mode in memory, and use
the POWER ON SETUP item to specify the power-on setup (
Setups - Save, Power-on, and Recall
for details). The Dual V and I display cannot be saved. A reset will not change this setting.
Recalling a setup may change the setting. If setup recalling has a channel function set to
something other than voltage or current then this setting is disabled otherwise the setting is left
unchanged.
Selecting (enabling) Dual V and I will switch the function to voltage for each channel unless the
function is already voltage or current. Dual V and I will be disabled if you change the display mode
on either channel to be Pulse Current, Long Integration, or DVM Input (Channel #2 only).
To select a display mode:
1. Press
the
DISPLAY
key.
2. Press
the
▲
or
▼
keys to scroll to the desired display mode.
3. Press
the
or keys to select Channel
#1
or
#2
.
4. With the desired mode and active channel displayed, press
ENTER
.
NOTE
With DUAL V AND I DISPLAY mode enabled, there is no indicator on the front
panel about voltage protection or current limit state. See
Section 2
for more
information on voltage protection and current limit.
Table 1-1
Display Modes
Battery channel (#1)
Charger channel (#2)
• SINGLE V AND I
• DUAL V AND I
• LONG INTEGRATION
• PULSE CURRENT
• SINGLE V AND I
• DUAL V AND I
• LONG INTEGRATION
• PULSE CURRENT
• DVM INPUT
NOTE
Switching back to the original active channel will display the initial setting for that
channel.
▲
▲
Summary of Contents for 2308
