Index
Model 2308 Portable Device Battery/Charger Simulator User’s Manual
I-4
2308-900-01 Rev. A / July 2008
Subsystems reference tables
.........11-2
SCPI programming
............ 1-15
,
3-12
,
4-11
DVM
...............................................2-19
Measure V and I, and DVM input
...2-17
Outputting voltage and current
.......2-13
SDC (selective device clear)
....................6-6
Selective device clear
...............................6-6
Sending a response message
................6-11
SENSe command summary
...................11-6
SERIAL NUMBER
..................................1-13
Serial polling
.................................... 6-6
,
7-7
Serial polling and SRQ
.............................7-7
Service request enable register
................7-7
Setting the GPIB timeout for Responses
..6-4
Short-form rules
........................................6-9
Signal-Oriented Measurement commands
9-2
Single command messages
...................6-10
Sink operation
.........................................2-19
SOURce command summary
...............11-13
SPE, SPD (serial polling)
................. 6-6
,
7-7
Specifications
...........................................1-3
Specifying the timeout length for the pulse
4-4
Standard event status
...................... 7-8
,
7-9
Status
byte register
......................................7-6
command summary
......................11-14
model structure
.................................7-3
register sets
............................. 7-2
,
7-8
Status byte and
service request (SRQ)
......................7-5
service request commands
..............7-8
SRQ
..................................................7-2
status register
16-bit
................................................7-5
Step measurements
Integration time
...............................3-25
SYSTem command summary
...............11-15
T
Temperature coefficient
............... 12-4
,
13-3
TRIG LEV RANGE
.................................1-13
Trigger
....................................................9-10
Trigger continuous mode
........................9-10
Trigger delay
.............................................3-3
High Pulse current measurement
.....3-3
Trigger edge, trigger level, and trigger
level range
........................................4-7
Trigger level
..................................... 3-2
,
4-3
Trigger on talk
...........................................9-9
Both channels
...................................9-9
Triggering the start of the measurement
..4-3
U
Using common and SCPI commands
in the same message
.....................6-11
Using FAST, SEARch, and DETect
3-16
,
4-12
Using TimeOUT
........................................4-5
V
Verification
Ambient temperature
......................12-2
Environmental conditions
...............12-2
Line power
......................................12-3
Recommended test equipment
...... 12-3
Test requirements
.......................... 12-2
Warm-up period
............................. 12-2
VFD BRIGHTNESS
.................................. 1-6
Voltage drop equation
............................ 2-12
W
Warranty information
................................ 1-2
Waveform filtering
.................................... 4-2
Summary of Contents for 2308
