![background image](http://html2.mh-extra.com/html/keithley/2308/2308_user-manual_3948247065.webp)
2308-900-01 Rev. A / July 2008
Return to
Section Topics
3-11
Model 2308 Portable Device Battery/Charger Simulator User’s Manual
Section 3: Pulse Current Measurements
13. Press
ENTER
to save your settings and return to the main menu.
14. If the message appeared, repeat Step
9
until a valid trigger level is found.
15. Press
MENU
to exit the menu structure and display pulse current measurements.
TRIG NOT DETECTED message
The TRIG NOT DETECTED message is displayed when specific TLEV settings, coupled with
corresponding current range, have been set and a trigger has not been detected. Refer to
Table 3-
2
for the message preconditions.
NOTE
If the trigger level is still too low or too high, the TRIG NOT DETECTED
message will be displayed briefly. Note that it may take a few seconds for the
message to appear (see
TRIG NOT DETECTED message
for more
information).
Table 3-2
TRIG NOT DETECTED message
TLEV setting
Current range
TRIG NOT DETECTED Message displayed?
90 mA for 500 mA current
range
5 A
No (not checked because TLEV setting does not match
current range)
90 mA for 500 mA current
range
50 mA
No (not checked because TLEV setting does not match
current range)
0.75 A for 5 A current range
5 A
May appear
*
0.1 A for 500 mA current
range
500 mA
May appear
*
3.0 A for 5A current range
5 A
May appear
*
0.03 A for 50 mA current
range
50 mA
May appear
*
0.003 A for 5 mA current
range
5 mA
May appear
*
1.1 A for 5 A current range
5 mA
No (not checked because TLEV setting does not match
current range)
1.1 A for 5 A current range
500 mA
No (not checked because TLEV setting does not match
current range)
*
Depends upon the OUTPUT:
If OFF, the message will appear.
If ON, display of the message will depend on the trigger level setting. If trigger level setting greater than the expected low
measurement and less than the expected high measurement, the message will not appear.
For example, if the expected pulse high value is 2.2 A and the expected pulse low value is 0.5 A, the output is on, and
the current range is 5 A, notice the following results:
Setting 0.3 A
TRIG NOT DETECTED is displayed (setting too low).
Setting 3.0 A
TRIG NOT DETECTED is displayed (setting too high).
Setting 1.1 A
The message will not display (setting correct).
Summary of Contents for 2308
