49
7.
Test operation of the lock prior to closing the container .
Replace Battery - Vertical Lock:
1.
Remove the battery compartment cover located on the right side of the
lock front by prying the cover off using a small flat bladed screwdriver.
Pry around the top and bottom ends of the battery cover in the area of
the cover fasteners until the fasteners are fully free of the lock front.
2.
Withdraw the battery half way out of the battery compartment by pulling
out the extractor ribbon as far as it will go.
3.
Grasp the end of the battery and pull it fully out of the battery compart-
ment and unsnap the connector from the old battery.
4.
Reconnect a fresh 9 Volt Alkaline or Lithium battery to the battery
connector.
5.
Insert the battery straight into the battery compartment making sure that
the extractor ribbon is routed on the side of the battery away from the
container. Ensure that the extractor ribbon is routed correctly so that
the battery can again be easily withdrawn from the battery compart-
ment.
6.
Tuck the end of the ribbon into the compartment so that it is not
exposed but is still accessible.
7.
Place the cover over the battery compartment. Locate the fasteners in
their respective holes and press the fasteners down until the cover is
fully in place.
Battery Assist
If the Battery Assist option is included on your lock, there are no operational
differences; however, the lock will act differently than a non-battery assist
lock when it is in a Time Delay or Open Window period. When a 9 Volt
Alkaline or Lithium battery has been installed for Battery Assist, the LEDs
will continually flash throughout the duration of a Time Delay or Open
Window period.
Summary of Contents for AUDITCON 100 series
Page 1: ...OPERATING INSTRUCTIONS AUDITCON LOCK 100 200 400 500 SERIES...
Page 56: ...52...
Page 57: ...NOTES...
Page 58: ......
