Kaba Mas AUDITCON 100 series, Operating Instructions Manual, Page: 48 / 60

44
3. Enter the Master User combination. Short red flashes begin to display.
From the time these flashes begin, you have 10 seconds to properly
place and hold the prepared SA key to the lock key reader. If you do
not properly hold the key to the lock key reader within the 10 second
period, short red flashes followed by three long red flashes display to
indicate an error and you will need to re-key the operation. If the SA
key has not been properly initialized, three long red flashes display.
Helpful Hint: For Round housing lock models, press down on the
top of the key with your thumb, holding the key at an angle
against the key reader to ensure that the key makes proper
contact with the key reader. For Vertical housing lock models,
press and hold the key directly against the key reader.
4. Ensure that the key remains connected to the key reader until the lock
has completed the upload (
upon completion, simultaneous green
and red flashes display ).
Start Time Window Lockout
This feature is available in the Model 500 locks. It enables the the Master
User, User 20 , or any Supervisor (if operating in Supervisory/Subordinate
mode) to disable lock access for the current open time window. Access to
lock entry will remain disabled until the time of the next open time window
as defined by the Time Windows function. The lock will not open during this
time but it will accept keystrokes and will start a time delay for opening the
lock. If the end of the delay falls in the next open time window, the lock can
be opened at that time.
To start Time Window Lockout, complete the following steps:
1. For a PowerStar version of the lock, power the lock by briskly turning
the dial back and forth in both directions.
2. Press Enter, Enter and then 7 . Simultaneous green and red flashes
display.
3. Enter the Master User, User 20 or Supervisor Combination. Simulta-
neous green and red flashes display.