20
Detect if Super Master Combination is Active
To determine if the Super Master combination is active (i.e., the default
factory Super Master User PIN has been changed) within either factory or
shelve mode, complete the following steps:
1.
For a PowerStar version of the lock, power the lock by briskly turning
the dial back and forth in both directions.
2.
Press
Enter
,
Enter
and then
2
. If the Super Master User combination is
active, a red flash will display. If the Super Master User combination is
inactive a green flash will display.
Shelve Lock (Super Master User)
Note:
Once a lock is shelved, all information stored in the lock (except
audit information, time delay settings, and the Super Master
User combination, if any) is lost.
To shelve a lock using the Super Master User combination, complete the
following steps:
1.
Ensure that the lock is in any mode other than factory mode or shelve
mode.
2.
For a PowerStar version of the lock, power the lock by briskly turning
the dial back and forth in both directions.
3.
Press
Enter
and then
0
. Simultaneous green and red flashes display.
4.
Enter the Super Master User combination (i.e., ID “00” followed by the
six-digit PIN). The lock is now shelved.
Change Super Master User PIN
To change the Super Master User PIN anytime while the lock is in shelved
mode, complete the following steps:
1.
Shelve the lock under normal circumstances by completing Steps 1-5
in the “Shelve Lock” section on page 34.
2.
Press
Enter
and then
0
. Simultaneous green and red flashes display.
Summary of Contents for AUDITCON 100 series
Page 1: ...OPERATING INSTRUCTIONS AUDITCON LOCK 100 200 400 500 SERIES...
Page 56: ...52...
Page 57: ...NOTES...
Page 58: ......