25
After the specified delay period has expired, you will have 01-20 minutes
(the duration of this delayed opening window is user-defined) in which to
re-enter the valid combination. During this 01-20 minute window, the lock
will display two green flashes, each accompanied by a beep, every four
seconds as long as it remains powered. If the lock powers down and you
attempt to re-power it during this window, the lock will act the same as it did
as the beginning of the delayed opening window. If the valid combination is
not entered within the window, the lock will not open. A valid combination
entered after the delayed opening window has expired will simply cause
another time delay period to begin.
The default delay time is zero (i.e., the lock can be opened immediately
after the combination requirements are met). To set the delay time and the
delayed opening window, complete the following steps:
1.
For a PowerStar version of the lock, power the lock by briskly turning
the dial back and forth in both directions.
2.
Press
Enter
and then
5
. Simultaneous green and red flashes display.
3.
Enter the Master User combination. Simultaneous green and red
flashes display.
4.
Enter the number of minutes (05-99 for Model 100, 200, 400; 01-99 for
Model 500 ) you want to delay the lock opening. Simultaneous green
and red flashes display.
Note:
T
o disable delay time, enter “00” for the previous step.
5.
Enter the delay time again for verification. Simultaneous green and red
flashes display.
6.
Enter the number of minutes (01-20) for the delayed opening window
(i.e., the number of minutes in which the user must enter a valid
combination after the delay period has expired).
7.
Enter the number of minutes for the delayed opening window again for
verification.
Summary of Contents for AUDITCON 100 series
Page 1: ...OPERATING INSTRUCTIONS AUDITCON LOCK 100 200 400 500 SERIES...
Page 56: ...52...
Page 57: ...NOTES...
Page 58: ......