32
5.
For a
Spindled
version of the lock, dial right (clockwise) until the lock
bolt is retracted and then open the container. If you have a
Spring Bolt
,
you must dial right and hold the dial until the container has been
opened so that the bolt does not “spring” back into the extended
position. For a
Non-Spindled
version of the lock, disengage the
container boltworks to unlock the lock and open the container simulta-
neously.
Note:
The lock will not open if excessive force is applied to the end
or side of the bolt.
You should check for these conditions during
installation.
Open the Lock/Container with Time Delay Set
Note:
In Supervisory/Subordinate mode, a Supervisor must enable
lock access for his assigned Subordinate User(s) before these
Subordinate User combination(s) can open the lock.
Note:
A change in delayed opening will not take effect until the next
opening.
If a time delay has been set, complete the following steps to open the lock:
1.
For a PowerStar version of the lock, power the lock by briskly turning
the dial back and forth in both directions.
2.
If this is a Spindled version of the lock, position the lock dial to the
HOME
position.
3.
Enter the valid combination. Wait for the time delay to expire. (While
powered, the lock will display two red flashes approximately every four
seconds for the duration of the delay.) Once the time delay has
expired, the lock will begin to display two green flashes, each accom-
panied by a beep, every four seconds. This indicates that the delayed
opening window has begun.
Summary of Contents for AUDITCON 100 series
Page 1: ...OPERATING INSTRUCTIONS AUDITCON LOCK 100 200 400 500 SERIES...
Page 56: ...52...
Page 57: ...NOTES...
Page 58: ......
