30
4.
Enter the two-digit Supervisor ID you entered in Step 3 again for
verification. If you are enabling lock access, three slow green flashes
followed by simultaneous green and red flashes display. Any valid
Subordinate User combination(s) assigned to the Supervisor ID can be
entered at any time to open the lock. If you are disabling lock access,
simultaneous green and red flashes display. The Subordinate
combination(s) assigned to the Supervisor ID can no longer open the
lock until lock access is again enabled by a Supervisor.
Change PIN
Any lock personnel (Master, Supervisor, Access User or Subordinate User)
can change his PIN at any time (however, a User ID can never be
changed). To change a PIN, complete the following steps:
1.
For a PowerStar version of the lock, power the lock by briskly turning
the dial back and forth in both directions.
2.
Press
Enter
and then
1
. Simultaneous green and red flashes display.
3.
Enter the combination (User ID + PIN) of the user for which the PIN is to
be changed. Simultaneous green and red flashes display.
4.
Enter the new combination (User ID + PIN) for the user. Simultaneous
green and red flashes display.
5.
Enter the new combination (User ID + PIN) for the user again for
verification. Simultaneous green and red flashes display.
Open the Lock/Container
Note:
For a Spindled version of the lock, you must position the lock
dial to the
HOME
position (i.e., the lip on the dial will cover the
red “open lock” indicator) before a combination is entered.
Note:
In Supervisory/Subordinate mode, a Supervisor must enable
lock access for his assigned Subordinate User(s) before the
Subordinate User combination(s) can open the lock.
Summary of Contents for AUDITCON 100 series
Page 1: ...OPERATING INSTRUCTIONS AUDITCON LOCK 100 200 400 500 SERIES...
Page 56: ...52...
Page 57: ...NOTES...
Page 58: ......
