23
Note:
Once the Master User PIN has been set, the factory PIN
“502550” will no longer open the lock. In addition, the Master
User PIN cannot be changed back to the default PIN of
“120943”. The lock is now operating in Independent mode and
Single User access.
After the new Master User PIN has been set, you may want to change the
lock operation mode. Refer to the following
Set Operating Mode and
Identify Lock
section for information on performing this procedure.
Set Operating Mode and Identify Lock
Note:
Only a Master User can change the lock operation mode. It is
assumed that mode changes, other than a change at initial lock
set up, will be rare since such a change has a significant impact
on all lock personnel.
When you change the operating mode, the lock will also prompt you to
enter a two-digit number (01-99) that will identify the lock in the audit report.
This ID assignment is optional. If you do not want to assign an ID to the lock,
you can enter “00” at this prompt. To change the mode of operation for the
lock and identify the lock for audit purposes, complete the following steps:
1.
For a PowerStar version of the lock, power the lock by briskly turning
the dial back and forth in both directions.
2.
Press
Enter
and then
2
. Simultaneous green and red flashes display.
3.
Enter the Master User combination. Simultaneous green and red
flashes display.
4.
Enter
01
for Single User access or
02
for Dual User access. Simulta-
neous green and red flashes display.
5.
Enter
01
or
02
again to verify the mode you selected in Step 4.
Simultaneous green and red flashes display.
6.
Enter
01
for Independent mode or
02
for Supervisory/Subordinate
mode. Simultaneous green and red flashes display.
Summary of Contents for AUDITCON 100 series
Page 1: ...OPERATING INSTRUCTIONS AUDITCON LOCK 100 200 400 500 SERIES...
Page 56: ...52...
Page 57: ...NOTES...
Page 58: ......
