Juniper SRX3400, Hardware Manual, Page: 99 / 232

CHAPTER 9
Performing Initial Software Configuration
on the SRX3400 Services Gateway
This section includes the following topics:
•
SRX3400 Services Gateway Software Configuration Overview on page 85
• Performing Initial Software Configuration on the SRX3400 Services Gateway on page 86
SRX3400 Services Gateway Software Configuration Overview
The services gateway is shipped with the Junos operating system (Junos OS) preinstalled
and ready to be configured when the services gateway is powered on. There are three
copies of the software: one on a CompactFlash card (if installed) in the Routing Engine,
one on the hard disk in the Routing Engine, and one on a USB flash drive that can be
inserted into the slot in the Routing Engine faceplate.
When the services gateway boots, it first attempts to start the image on the USB flash
drive. If a USB flash drive is not inserted into the Routing Engine or the attempt otherwise
fails, the services gateway next tries the CompactFlash card (if installed), and finally the
hard disk.
You configure the services gateway by issuing Junos OS command-line interface (CLI)
commands, either on a console device attached to the
RE CONSOLE 0
port on the SFB,
or over a Telnet connection to a network connected to the
RE ETHERNET 0
port on the
SFB.
Gather the following information before configuring the services gateway:
• Name the services gateway will use on the network
• Domain name the services gateway will use
•
IP address and prefix length information for the Ethernet interface
•
IP address of a default router
• IP address of a DNS server
• Password for the root user
85 Copyright © 2013, Juniper Networks, Inc.