Juniper SRX3400, Hardware Manual, Page: 135 / 232

11.
Press both of the ejector handles inward to seat the SCM.
12.
Tighten the captive screws at either end of the SCM faceplate.
Figure 55: Installing an SCM
g036099
13.
Power on the services gateway by pressing the Power button on the front panel of
the SFB for three to five seconds.
If the services gateway is configured for chassis clustering, the
OK/FAIL
LED on the
SCM faceplate should blink green, then light steadily. For more information about
configuring and managing chassis clusters, see the chapter “Chassis Cluster” in the
Junos OS Security Configuration Guide .
Related
Documentation
SRX3400 Services Gateway SRX Clustering Module on page 24
•
•
Installing an SRX Clustering Module in the SRX3400 Services Gateway on page 65
Replacing a CFM Card on the SRX3400 Services Gateway
The most common modules for the services gateway use theCFM format:
•
IOCs
• NP-IOCs
• SPCs
•
NPCs
NOTE: For the services gateway to meet NEBS and ETSI standards, it must
not have any two SPCs installed side by side in the CFM slots in the front of
the chassis (CFM slots 1 through 4). You can install SPCs side by side in the
CFM slots in the rear of the chassis (CFM slots 5 through 7). See
“SRX3400
Services Gateway NEBS and ETSI Compliance” on page 176 for more
information.
121 Copyright © 2013, Juniper Networks, Inc.
Chapter 12: Replacing Hardware Components on the SRX3400 Services Gateway