Juniper SRX3400, Hardware Manual, Page: 133 / 232

Figure 53: Installing a Routing Engine
g036027 Captive screw Ejector levers
14.
Reconnect cables previously attached to the AUX or USB ports.
15.
Power on the services gateway by pressing the Power button on the front panel of
the SFB for three to five seconds. Wait for the services gateway to start. The
OK/FAIL
LED on the Routing Engine faceplate should blink green, then light steadily.
NOTE: The Routing Engine might require several minutes to boot. If after
this time the OK/FAIL LED is red, remove and reinstall the Routing Engine.
If the OK/FAIL LED remains red, the Routing Engine is not functioning
properly. Contact your customer support representative.
To check the status of the Routing Engine:
user@host> show chassis routing-engine
Routing Engine status:
Slot 0:
Current state Master
Election priority Master (default)
DRAM 1016 MB
Memory utilization 39 percent
CPU utilization:
User 0 percent
Background 0 percent
Kernel 3 percent
Interrupt 0 percent
Idle 97 percent
Model RE-SRX3400
Start time 2008-11-03 10:25:37 PST
Uptime 1 day, 2 hours, 33 minutes, 6 seconds
Last reboot reason 0x1:power cycle/failure
Load averages: 1 minute 5 minute 15 minute
0.02 0.04 0.00
For more information about using the CLI, see the Junos OS manuals.
Related
Documentation
Required Tools and Parts for Replacing Hardware Components on the SRX3400
Services Gateway on page 110
•
•
Replacing an SRX Clustering Module on the SRX3400 Services Gateway on page 120
119 Copyright © 2013, Juniper Networks, Inc.
Chapter 12: Replacing Hardware Components on the SRX3400 Services Gateway