Juniper SRX3400, Hardware Manual, Page: 223 / 232

APPENDIX F
Product Recycling
• Removing the Battery from the Routing Engine of an SRX3400 Services Gateway for
Recycling on page 209
Removing the Battery from the Routing Engine of an SRX3400 Services Gateway for
Recycling
The Routing Engine installed in the services gateway contains a CR2032 .3.0-volt lithium
battery. The coin-shaped battery is approximately 3/4 in. (19 mm) in diameter. The
battery is estimated to last for over 50 years.
Before recycling a Routing Engine or the services gateway chassis, remove the battery
from the Routing Engine for recycling.
Before you begin to remove the battery:
•
Before you remove the Routing Engine, you must power off the services gateway. For
instructions, see
“Powering Off the SRX3400 Services Gateway” on page 82 .
• Ensure that you have the following parts and tools:
• Phillips (+) screwdriver, number 2
•
Electrostatic discharge (ESD) grounding strap
The Routing Engine is located in the rear slot labeled RE0 on the services gateway. To
remove the battery from a Routing Engine in the services gateway (see
Figure 78 on page 210 ), perform the following steps:
1.
Attach the ESD grounding strap to your bare wrist, and connect the strap to one of
the ESD points on the chassis.
2.
Remove the Routing Engine, as described in “Replacing a Routing Engine on the
SRX3400 Services Gateway” on page 118 .
3.
Locate the coin-shaped CR2032 battery on the left side of the Routing Engine (see
Figure 78 on page 210 ).
4.
Remove the battery from its socket.
5.
Recycle the battery as required.
209 Copyright © 2013, Juniper Networks, Inc.