Juniper SRX3400, Hardware Manual, Page: 147 / 232

6.
Remove the cable lugs from the terminals.
7.
Carefully move the power cables out of the way.
8.
Push the tab on the left edge of the power supply to the right.
9.
Pull the power supply straight out of the chassis.
Figure 64: Removing a DC Power Supply
g036086
10.
Orient the replacement power supply so that the tab is on the left side, as shown in
Figure 65 on page 133 .
Figure 65: Inserting a DC Power Supply
g036085
11.
Using both hands, slide the replacement power supply straight into the chassis until
the power supply is fully seated in the chassis slot. Make sure the tab on the left edge
of the power supply clicks into place. The power supply faceplate should be flush
with any adjacent power supply faceplate.
133 Copyright © 2013, Juniper Networks, Inc.
Chapter 12: Replacing Hardware Components on the SRX3400 Services Gateway