Juniper SRX3400, Hardware Manual, Page: 91 / 232

8.
Secure the grounding cable lug to the chassis, first with the washers, then with the
screws.
9.
Dress the grounding cable and verify that it does not touch or block access to services
gateway components, and that it does not drape where people could trip on it.
Related
Documentation
Required Tools and Parts for Grounding and Providing Power to the SRX3400 Services
Gateway on page 75
•
•
Connecting the SRX3400 Services Gateway to an AC Power Source on page 77
•
Connecting the SRX3400 Services Gateway to a DC Power Source on page 79
•
Powering On the SRX3400 Services Gateway on page 81
•
Powering Off the SRX3400 Services Gateway on page 82
Connecting the SRX3400 Services Gateway to an AC Power Source
You connect AC power to the services gateway by attaching power cords from the AC
power sources to the AC appliance inlets located on the power supplies.
WARNING: To meet safety and electromagnetic interference (EMI)
requirements and to ensure proper operation, you must properly ground the
services gateway chassis before connecting power. See
“Grounding the
SRX3400 Services Gateway” on page 76 for instructions.
CAUTION: Do not mix AC and DC power supplies within the same services
gateway. Damage to the services gateway might occur.
To connect the AC power cords to the services gateway for each power supply:
1.
Locate the power cord or cords you will use to connect the services gateway to AC
power. The services gateway is not shipped with AC power cords. You must order
them separately using the model numbers shown in
“SRX3400 Services Gateway AC
Power Cord Specifications” on page 191 .
2.
Insert the appliance coupler end of the power cord into the appliance inlet on the
power supply, as shown in
Figure 42 on page 78 .
77 Copyright © 2013, Juniper Networks, Inc.
Chapter 8: Grounding and Providing Power to the SRX3400 Services Gateway